Ensave Air Compressor Energy Saving Systems

Ensave Air Compressor saving principle and structure

Saving Principle
To understand the saving principle of our Ensave system, it will be appropriate if we take an example of one of our customer air compressor's data. The company's compressor pressure set to: maximum pressure of 0.8Mpa and the lower pressure of 0.53Mpa. For a unit load, the loading time and the unloading time are about 2 / 1. Part of the air compressor's time works in the unloaded state with low efficiency, and power wastage. At this point the so-called unloading where the compressor is not acting, and in the empty state, and then this part of the energy is wasted. Another reason for the lower limit set at 0.53Mpa, that is the minimum 0.53Mpa gas can be used in production, and the pressure increases from 0.53Mpa to 0.8Mpa (loading) will result in a large wastage of electricity. With our Ensave air compressor dedicated Saver which uses a specially designed pressure control system which sets a reasonable supplies pressure, such as for this case 0.55Mpa. When the system pressure is higher than this pressure, Ensave Saver reduces the compressor's speed, and then doubled down the compressor power consumption.

When the gas consumption increases, Ensave Saver increases the compressor speed so causing rapid increases in pressure in a short-term. And so achieve two objectives: energy-saving and constant pressure air supply. Meanwhile, the compressor motor starting mode becomes soft starter, which in turn can protect the compressor and the motor, and greatly extended their service life.